You will need to unplug the mic and plug in this cable when using the RigPi. I have chosen to use the cable that goes from the RJ45 on the audio card to the Mic connector on the front of the radio. You will also need an audio cable to connect the transmit and receive audio from the radio to the RigPi. The one I tested was from Amazon and here is the link: You will need to buy a CI-V to USB cable. The CAT control will be controlled from the 1/8 inch plug CI-V port in the back of the radio. This radio does not have a USB plug for CAT control or audio. Please compare the menu settings to the ones I have provided here for the ProIII. Icom 756pro and IC-756proIII radio setup (the set up for the Icom 756pro and 756proIII are the same) Introduction - Whiles these instructions were developed from the Icom 756proIII manual they should work for all Icom 756xxx radios. NOTE: If you install the new audio file per Howard's instructions you will need to use the new overlay as the default system selection in mumble since you are using the audio card.
0 Comments
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |